| ||
|
::General discussion front page ::Post new message | ||
| ||
Country:International
This is a general discussion forum about petanque. All issues may be discussed here.
Posted by: Jeff Widen (
) at 2007-09-25 16:23:37
Posting has been displayed 688 times
I imagine a boule to be measured for balance could be placed upon a type of teeter-totter (see-saw) with equal weights at either end and a slight depression at it's center on to which the boule can be placed. The "circle" of the boule's weld would run parallel to the teeter-totter's plane. If one part of the weld were heavier, than it'd fall in that direction.
 |
The Balance of Boules F. William Baker 2007-09-24 19:17:42
The Balance of Boules Don Nairn 2007-09-24 21:37:17
The Balance of Boules Jeffrey Widen 2007-09-24 21:52:49
The Balance of Boules Guy Therrien 2007-09-24 22:41:58
The Balance of Boules F. William Baker 2007-09-25 13:39:54
The Balance of Boules Ray Ager 2007-09-25 14:34:06
The Balance of Boules Jeff Widen 2007-09-25 16:23:37
The Balance of Boules Tony Andersson 2007-10-03 12:37:50
The Balance of Boules Jeff Widen 2007-10-03 15:12:01
The Balance of Boules F. William Baker 2007-10-06 15:42:33
The Balance of Boules F. William Baker 2007-10-11 13:36:44
|
| ||
|
::General discussion front page ::Post new message | ||
| ||
